X4M300 Presence Sensor

Discussion in 'X2 & X4 SoC' started by Momina_Sajid, Mar 6, 2018.

  1. Momina_Sajid

    Momina_Sajid New Member

    I'm planning to buys an X4M300 presence sensor to monitor presence/ respiration through it. I'm a beginner in this matter and would appreciate all sort of beginner level guidance as to what controller would be most suitable for to use along with it?
    Also, do we have to do the entire coding as in on arduino or are there some basic codes giving the output e.g. of presence or sensor data?
  2. Charlie Shao

    Charlie Shao Moderator Staff Member

    Hi Momia,
    I want to remind you that X4M300 is just a presence sensor, if you need respiration output, you need to use X4M200. You can start from this document to learn about XeThru sensors:
    I assume you are going to use MCU as "controller", then you can start from MCPW:
    There is an example based on Atmel ATSAMG55 MCU.
    If you choose to use Arduino, there are no official codes for it, but there is an Arduino library made by our user for X2M200. You can refer: https://www.xethru.com/community/resources/arduino-library.36/