[X4M202 Program]

Discussion in 'General' started by Ash, Sep 17, 2019.

  1. Ash

    Ash New Member

    Hi, while going through the X4M202 datasheet, i didnt find the details about 10-pin connector mounted on top of the module. where can i use this and how?
    Also what are the uses of 16-pin connector and 10-pin connector mounted on module? Please suggest~
    Thanks,
     
  2. Charlie Shao

    Charlie Shao Moderator Staff Member

    Hi Ash,
    The 10-pin connector is a standard debug port which is compatible with Ateml-ICE, which means X4M202 can be used also as a development board from HW view, but it is running custom firmware from XeThru as a respiration sensor. If you reprogram it the firmware cannot be recovered. You can find the 16-pins definition from X4M202 datasheet.
     
    Ash likes this.