X2 SPI Interfacing

Discussion in 'X2 & X4 SoC' started by Antoine Théry, Sep 14, 2016.

  1. Antoine Théry

    Antoine Théry New Member

    Hello,

    I'm currently trying to use directly the Xethru X2 Chip, in two ways, but I'm facing two major problems :
    • On one side, I have the Ancho Chips+Salsa Kit, but I cannot work on it directly, because I don't have the sources of SalsaLib and RadarLib
    • On the other side, I have the X2M200 module, but I cannot wire directly the X2 chip using SPI, since the test points on the board are not labelled.
    Can you provide us the access to RadarLib and SalsaLib, and the placement of the SPI test points, and may be the source of the firmware of the Atmel ATSAM4 Cortex M4F core ?

    Regards,
    Antoine
     
  2. Olav Liseth

    Olav Liseth Administrator Staff Member

    Hi Antoine,

    You must use the Ancho kit to access the X2 directly. This is possible with radarlib from the BB platform, for other usages you can contact support@flatearthinc.com .

    Best,
    Olav
     
  3. Tan Syh Rn

    Tan Syh Rn New Member

    Hi Olav,

    I wonder do you have any SPI interfacing library for Arduino?

    Regards,
    Syh Ren
     
  4. Olav Liseth

    Olav Liseth Administrator Staff Member

  5. Tan Syh Rn

    Tan Syh Rn New Member

    Hi Olav,

    I am looking to interfacing with the X2 chip directly - not with any of the development kit.

    Syh Ren