Reset in Xethru presence module

Discussion in 'Presence Sensor' started by SMRITHYRK, Sep 23, 2019.

  1. SMRITHYRK

    SMRITHYRK New Member

    Hi Xethru Team,

    We are currently on Xethru presence sensor module. We are getting the presence information and the input pin is in low state.

    After this if we are giving a signal to the xethru module's reset pin through another microcontroller, how much time will it take to come back to the new working state?
     
  2. Charlie Shao

    Charlie Shao Moderator Staff Member

    Hi,
    The firmware start time should be less than 3 seconds. Then the sensor will start to initialize, the initialization time will cost around 20 or 120 seconds depending on your noise map configuration. After that sensor will be able to report the present state.