XE 1.0.5 frames lost

Discussion in 'XeThru Explorer' started by Anwar Elhadad, Nov 16, 2018.

  1. Anwar Elhadad

    Anwar Elhadad Member

    I noticed that I am getting so many frames lost when sampling. I was think about reducing the number off bins I am using to resuced the work on the processor. is that effective? does that helps the frame rate? and do you have other tips to improve the FPS?
    Thanks.
     
  2. Charlie Shao

    Charlie Shao Moderator Staff Member

    Hi Anwar,

    I reckon that you are reading radar raw data at XEP level. I did not see frames lost even at very high FPS as discussed at this thread: https://www.xethru.com/community/th...-high-frame-rate-more-than-400.204/#post-1060. The limitation mainly comes from the host processor. Depends on if the processor can process data at the interval between two continue frames in time.

    X4 user guide provides FPS configuration knowledge:
    https://www.xethru.com/community/resources/xethru-x4-radar-user-guide.149/