Communicating with the device for RF Parameter Data

Discussion in 'Respiration Sensor' started by Vinay Gotnakodlu Hegde, May 26, 2018.

  1. I am trying to evaluate the RF performance of the X4M200 development kit and want to check RF performance metrics like sensitivity, RSSI, frequency chosen, SNR, Tx power, etc. Can I use command prompt or serial communication to talk to the device ? If yes, is there any documentation on the steps to setup the device and APIs required to print the above mentioned RF parameters ?
     
  2. Charlie Shao

    Charlie Shao Moderator Staff Member

    Hi Vinay,
    Please check the X4 datasheet, most of them can be got by reading related registers.
    The regmap_example.py shows how the read and write X4 registers.