Bootloader mode each time

Discussion in 'XeThru Explorer' started by JC Kuo, Sep 5, 2019.

  1. JC Kuo

    JC Kuo New Member

    Is it normal??

    when we connect X4M300 with PC and execute XeThru Explorer, it will show as image.
    And FW version is UNKNOW.
    We need to change version each connection.

    BTW, does XeThru Explorer not support resolution below to 1920x1080??

    Attached Files:

  2. Charlie Shao

    Charlie Shao Moderator Staff Member

    Hi Ju,
    Did you just connect with computer through the USB cable?
    Bootloader mode can be triggered either by software or IO pin state(see datasheet). Current firmware should show 1.6.8 if you already uploaded it one.

    I am not able to find a 720p screen to do a test now, but the screen resolution should have no influence on XE.