X4M200 Respiration Sensor Datasheet Rev E

Non-Conact Respiration Sensor

  1. Update to Rev D

    kristian saether
    - The previous two chapters to describe Baby and Adult Respiration Profile has been merged into one chapter that describes all four Respiration Profiles available from FW version 1.6.6.
    - Added Profile Settings Table for quick and easy lookup of length of Detection Zone, Fast PD length, Slow PD length and RPM Range for profiles
    - Noise Map Control settings re-written.
    - Added description of Normalized Movement Slow and Fast, which is available in all states except Initialization and Error, and comes as a movement list with 5.14 cm intervals only.
    - Added description of Normalized Movement Interval Slow and Fast, which is available in Breathing state only.
    - Added description of Default Noise Map.
    - Added description of default IO-pins being driven low and using tri-state with internal pull-up for high.
    - Added descriptions of Firmware Versions 1.5.10 and 1.6.0.
    - Changed description of Future versions of X4M200 in Firmware Versions chapter to make it clear this is not available yet.
    - Corrected PRF setting to be within regulations in FCC chapter. Was earlier wrongly stated to 15.875 MHz. Is now the correct value 15.1875 MHz. This is a documentation change only, no changes has been done in the FW.
    - Replaced Industry Canada (IC) with ISED. ISED was formerly known as Industry Canada.
    - Updated errata list for all firmware versions.
Return to update list...