Annapurna Firmware 1.6.8

X4M300 and X4M200 module firmware with release notes used for deployed FW upgrade

  1. Annapurna firmware version 1.6.8

    Marius Lind Volstad
    Changes in version 1.6.8
    • Fixed wrong trx_dac_step setting; thereby increased sensor signal-to-noise ratio by 3dB
    • Added IO pin for No Presence indication
  2. Annapurna firmware version 1.6.6

    Marius Lind Volstad
    Changes in version 1.6.6
    • Support for default noisemap
    • Protocol commands: delete_noisemap
    • RESPIRATION_4 and RESPIRATION_5 profiles
    • NormalizedMovementList output for respiration profiles
    • Fixed reset_to_factory_preset command did not clear all settings
    • Fixed UART receive crash after 1024B
    • Fixed sporadic communication issues
    • Fixed store noisemap frame glitch
  3. Annapurna firmware version 1.4.7

    Marius Lind Volstad
    Changes in version 1.4.7
    • GPIO functions
    • USRT communication mode
    • SW API for Certification mode
    • Fixed safe mode reset counting
    • Fixed idle/run mode toggling
  4. X4M300 firmware version 1.3.1

    Marius Lind Volstad
    Changes in version 1.3.1
    • Breathing pattern of closest breathing target
    • Fixed memory leaks
    • Changed firmware ID from "X4M300" to "Annapurna"
  5. X4M300 firmware version 1.2.1

    Marius Lind Volstad
    Changes in version 1.2.1
    • Change: Noise map will not initiate at reset if this is not selected in User Settings
    • Initialize Noise Map at Reset
    • Store Noise Map to sensor
    • Delete Stored Noise Map in sensor
    • Pulse-Doppler data output
  6. X4M300 firmware version 1.1.4

    Marius Lind Volstad
    New version of X4M300 firmware.

    Changes in version 1.1.4:
    • Slow Pulse-Doppler matrix changed from 15 to 20 seconds, which improves sensitivity to detect people that are still.
    • MovementSlow data shows movements for the previous 20 seconds.Previous FW version showed movements for the previous 15 seconds.
    • Improved breathing detection, which leads to less adaption of noise map, which improves sensitivity to detect people that are still.
    • Support for 2MB MCU (from X4M02 HW...